| ############################################################################### |
| # System clock source selection configuration |
| #define CLK_SRC_XTAL 1 |
| #define CLK_SRC_PLL 2 |
| NXP_SYS_CLK_SRC_SEL=0x02 |
| |
| ############################################################################### |
| # System clock frequency selection configuration |
| #define CLK_FREQ_13MHZ 1 |
| #define CLK_FREQ_19_2MHZ 2 |
| #define CLK_FREQ_24MHZ 3 |
| #define CLK_FREQ_26MHZ 4 |
| #define CLK_FREQ_38_4MHZ 5 |
| #define CLK_FREQ_52MHZ 6 |
| #define CLK_FREQ_32MHZ 7 |
| #define CLK_FREQ_48MHZ 8 |
| NXP_SYS_CLK_FREQ_SEL=0x02 |
| |
| ############################################################################### |
| # The timeout value to be used for clock request acknowledgment |
| # min value = 0x01 to max = 0x06 |
| #NXP_SYS_CLOCK_TO_CFG=0x06 |
| |
| ############################################################################### |
| # The delay to try to start PLL/XTAL when using sys clock 256/fc units = ~18.8 us |
| # min value = 0x01 to max = 0x1F |
| #NXP_CLOCK_REQ_DELAY=0x16 |
| |
| ############################################################################### |
| # MAX 20 RF configuration blocks are supported by MW. |
| # NXP RF configuration ALM/PLM settings |
| # This section needs to be updated with the correct values based on the platform |
| #NXP_RF_CONF_BLK_1={ |
| #} |
| |
| ############################################################################### |
| # NXP RF configuration ALM/PLM settings |
| # This section needs to be updated with the correct values based on the platform |
| #NXP_RF_CONF_BLK_2={ |
| #} |
| |
| ############################################################################### |
| # NXP RF configuration ALM/PLM settings |
| # This section needs to be updated with the correct values based on the platform |
| #NXP_RF_CONF_BLK_3={ |
| #} |
| |
| ############################################################################### |
| # NXP RF configuration ALM/PLM settings |
| # This section needs to be updated with the correct values based on the platform |
| #NXP_RF_CONF_BLK_4={ |
| #} |
| |
| ############################################################################### |
| # NXP RF configuration ALM/PLM settings |
| # This section needs to be updated with the correct values based on the platform |
| #NXP_RF_CONF_BLK_5={ |
| #} |
| |
| ############################################################################### |
| # NXP RF configuration ALM/PLM settings |
| # This section needs to be updated with the correct values based on the platform |
| #NXP_RF_CONF_BLK_6={ |
| #} |
| |
| |
| ############################################################################### |